90227 OnTrak Technical Test

1. Please enter the 12-digit SERIAL NUMBER from your OnTrak Test Utility Activation Dongle (Part Number 650-1957-00): *

2. Which PC software can be used to configure and download OnTrak? *

3. During the test and calibration procedure, what must the supply voltage be? *

4. If the OnTrak displays error code EC16, what would you do first? *

5. When "Office Check Mode" is set at the start of a new test: *

No results are displayed
All results are displayed throughout the recording
The first 5 successful results are displayed
All manual results are displayed, but not automatic results

6. Which of the following is TRUE? *

The recording data is lost if the AA batteries fail
The recording data is lost if the internal Lithium battery fails
The recording data will never be lost if any batteries fail
The recording data will be erased if you hold the Action button for 30 seconds
No answer is correct

7. The Patient Protection System ensures that: *

The monitor cannot be switched off during a measurement
The cuff pressure is never above 15mmHg for more than 3 minutes
The cuff pressure is less than 10mmHg at the end of a measurement
The minimum duration of a measurement is 30 sec

8. If the OnTrak displays event code EC85, your FIRST advice would be: *

Configure the monitor, and then use it immediately for an ABP recording
The monitor has a fault. It MUST NOT be used until it has been serviced
The monitor can be used but the calibration may be unreliable
Change the AA batteries, otherwise the monitor may not make a full 24h recording
The last reading has been discarded
You cannot use the monitor, because the Lithium battery needs changing

9. During the Functional Test and Calibration procedure, the Test Utility automatically checks: *

10. What is the purpose of the "Test Limits File", used in the Functional Test and Calibration procedure?

It contains the test parameters for the procedure.
It logs the results of the test.
It contains the firmware to upload into OnTrak.
It generates a warning message if the test fails.
No answer is correct.

11. During the Test and Calibration procedure, what is the time limit to enter a result? *

12. What is the purpose of Fixture 067-0175-00? *

13. Please enter your email address, and then send an email to gtsdc@spacelabs.com stating: "I have completed the OnTrak Technical Test Online".
With the email, you must attach the Test Utility Log for the monitor you calibrated during your self-training. *

Powered by SmartSurvey

Use our survey software to create your survey.